Perfect for my Monoprice Select Mini V2!

I have used one of these plates on my previous three printers. I recently bought this one for my new Saturn 4 ultra 16 K. Without a doubt, this is the single best upgrade you can make for any resin printer that you own. I don’t care if you’re looking at a heater, or a new vet, or anything at all. This is the first thing you buy. It saves so much headache, the adhesion is perfect, and the removal is absolutely flawless and simple. Don’t buy any other version, don’t look at some cheap knock off, buy this and enjoy some perfect printing.

I have two resin 3D printers, and I have installed Wham Bam Flexi Plate on both of them.

For me, it is a great improvement and helps to obtain high-quality prints.

Not what I expected, however, thanks to WhamBam customer support I learned how to use it correctly.

I was printing from edge to edge and complained that the plate was lifting at the edges. I was educated that this is not a good approach even without the plate. It can put too much stress on the FEP film due the suction. Support explain better ways to set up the print.

As always, the quality of their parts is the highest. There service is even better that anyone else's.

Good adhesion when heated, parts just pop off when cooled.

I use mine when I need to check for pieces sticking to the release film, and when I am cleaning a vat to change resin. It’s a great tool for both jobs. Happy I own it.

My favorite mat. The orange color makes it easy to find small parts. Hit spilled resin with a UV light, then it pops off.

I simply can't believe the texture and feel that this plate generates on the PLA... the gloss comes out almost mirror like in finish, and makes spectators doubt if they are indeed holding 3D printed PLA. I recommend it to anyone looking for special trratments to their work.

I've bought a 235x235 build plate like 5 years ago. I've only needed to replace it due to my mistake. Probably would last a lifetime now I got everything dialed in correctly.

Since getting the PEX plate for my Bambu Lab X1C, that is just about the only build plate I use. I have great success with printing on these. I use these on all my printers and have been extremely happy with them. I have not found a better build plate and have tried just about everything over the years.

This tool has made cleaning the resin tank effortless!

No matter if it‘s ASA, ABS, PETG, PC, PP, any Nylon or whatever filament you like to print, this plate does the job. Especially PETG which for me is a pain in the a.. does not stick to the plate like the devil to the soul. Easy to be cleaned the carbon fiber plate is a great added value for me. It is worth every penny you spend on it.

Wham Bam has been my goto build plate for every printer I've owned after I stopped using the Ender 3. Always works, always sticks, and if it doesn't it's usually my fault. I took a minute to write this review to confirm that this build plate also works with the H2S. It's not mentioned anywhere but that is what I bought this for and it fits perfectly.

Works great. There was a problem with one part, but they sent me a replacement. Great service.